Quick answer
LED Christmas lights cost very little to run. A typical LED string uses only a few watts, so six hours a night for the whole of December comes to well under 50p at the current price cap rate of 26.32p per kWh. When Which? measured six sets of LED lights, it estimated about 44p per string for two months of use. Old filament (incandescent) sets use several times more electricity and run hotter, so replacing them is worth it for safety as much as cost. The bigger risks with Christmas lights are not on your bill: they are cheap, unsafe sets from unknown sellers, indoor lights used outdoors, and lights left on overnight.
The running cost, with the sums shown
Cost = power in kW × hours used × unit rate
Under the Ofgem price cap for 1 October to 31 December 2026, the average electricity unit rate on Direct Debit is 26.32p per kWh. The wattages below are examples, not any specific product. The wattage of your own lights is printed on the plug, the transformer or the box.
| Example |
Energy for December (6 hours a night, 31 nights) |
Cost at 26.32p per kWh |
| LED string, 6W |
0.006 × 6 × 31 = 1.1kWh |
about 29p |
| Large outdoor LED display, 30W in total |
0.03 × 6 × 31 = 5.6kWh |
about £1.47 |
| Old filament string, 40W |
0.04 × 6 × 31 = 7.4kWh |
about £1.96 |
The unit rate changes again from 1 January 2027, so lights left up into the new year will be charged at the new rate for those days.
What Which? measured
Which? tested six strings of LED lights from popular UK retailers and published the results in November 2023, using a unit rate of 27.35p per kWh:
- One 200 or 400-bulb LED string cost about 0.74p a day for six hours’ use.
- Across 1 December to 31 January that came to about 44p per string.
- A 400-bulb string averaged 47p over the two months and a 200-bulb string 41p, so doubling the bulbs made little difference.
- The twinkling or flashing setting was the cheapest, at about 16p for the period, because the bulbs are off for part of the time.
Those figures used a slightly higher unit rate than today’s, so the same lights would cost a touch less now.
LED vs older filament lights
|
LED |
Filament (incandescent) |
| Electricity used |
Very low |
Several times higher |
| Heat |
Stay cooler |
Bulbs can get hot |
| If one bulb fails |
The rest usually stay lit |
Older sets may go dark |
| Safety |
Often extra-low voltage through a transformer |
Often full mains voltage on older sets |
London Fire Brigade recommends LED lights because they use less energy and stay cooler, and warns that the bulbs on fairy lights can get hot enough to scorch paper or fabric decorations. Electrical Safety First describes extra-low voltage lights as the safest choice. If your lights are old enough that you cannot remember buying them, this is a good year to replace them.
Safety checks that matter more than the bill
This advice is drawn from Electrical Safety First and London Fire Brigade.
Before you plug in
- Check the lights are not damaged or broken, with no loose wires.
- Look at the plug and socket for burn marks, and listen for buzzing or crackling.
- Do not use a set with a damaged cable or plug. Replace it.
- Mains-powered lights should have a UK 3-pin plug with a fuse.
Indoor or outdoor
- Only use lights outside if they are made for outdoor use. Outdoor lights should be marked with a water drop symbol or an IP code; the last digit shows water protection and should be 3 or higher.
- Keep plugs and transformers indoors, even when the lights themselves are rated for outdoors.
- Outdoor lights should be connected through a 30mA RCD-protected socket. If your consumer unit has no RCD protection, use an RCD plug.
While they are on
- Switch lights off and unplug them before bed and when you leave the house. A timer makes this automatic.
- Do not overload sockets, and keep extension leads and adaptors to a minimum.
- Keep bulbs away from paper and fabric decorations, and keep young children and pets away from cables.
Trees
- Modern artificial trees are usually fire retardant or resistant; check the packaging, and consider replacing a very old tree.
- Keep any tree away from heaters, fires and candles, and make sure it does not block your way out.
- A real tree needs water. London Fire Brigade says a tree can drink up to two pints a day, and that a dried-out tree burns quickly.
Getting a fair price
Christmas lights are often cleared at reduced prices after Christmas, which is a good time to buy for next year. If you need them now, compare like for like by bulb count and length, and be wary of a large “was” price on a set that has only been on sale for a few weeks. Our Deal Checker helps with that.
Browse Christmas gift deals, home and kitchen deals and the smart home section for timers and smart plugs, or describe what you need to the deal finder. Our guide to smart plugs, thermostats and energy monitors explains what a plug-in timer can and cannot do.
Amazon search links (Ad): indoor LED Christmas tree lights, outdoor LED Christmas lights, plug-in timer switches, RCD plug adaptors and outdoor weatherproof socket boxes. We don’t quote prices because they change through the day.